Page 1 of 2
I still need some work but I'll get there.
Posted: Fri May 15, 2015 9:11 pm
by Chucksta4x4
I think once I'm more familiar with the track I'll get some smoother runs in but this is my first complete run of the Reverse California Highway. It took some tuning before I could make a complete run because the cambered corners kept spinning the car out no matter how much I adjusted my driving. This was ran with a Thrustmaster TX with a GTE wheel, th8a H pattern shifter, and t3pa pedals. If someone has feedback feel free to post it. I'm always looking for help to go faster.
https://www.youtube.com/watch?v=MgpN32HMbDw
Re: I still need some work but I'll get there.
Posted: Tue May 19, 2015 6:40 am
by Trash McNish
Nice vid man thanks for sharing
Re: I still need some work but I'll get there.
Posted: Sat May 23, 2015 1:23 pm
by Chucksta4x4
You're welcome. I got a clean pass in last night on that course and the Nurburgring. As soon as I have the time I'll post them.
Re: I still need some work but I'll get there.
Posted: Sat May 23, 2015 10:29 pm
by Chucksta4x4
Here are the clean laps I made last night. The Nurburgring was my first time running it on Project Cars completely instead of sections. I enjoy this game a lot and the challenge.
https://www.youtube.com/watch?v=LXPFmdGVLcshttps://www.youtube.com/watch?v=xtF8ZA4OJAw
Re: I still need some work but I'll get there.
Posted: Wed May 27, 2015 9:21 am
by Chucksta4x4
A faster run but made a few mistakes even though the time never got invalidated.
https://www.youtube.com/watch?v=U5P8yU2uflM
Re: I still need some work but I'll get there.
Posted: Wed May 27, 2015 9:45 am
by Trash McNish
Nice job man I have noticed you can clip walls and keep the lap clean but again ty for posting keep it up.
Re: I still need some work but I'll get there.
Posted: Wed May 27, 2015 5:37 pm
by XessIV
Great work man. Liking those videos.
Re: I still need some work but I'll get there.
Posted: Thu May 28, 2015 1:01 pm
by Chucksta4x4
Thanks I'll see when I can get some better runs in!
Re: I still need some work but I'll get there.
Posted: Fri May 29, 2015 6:35 pm
by Chucksta4x4
Trying out a new way of doing my videos. Let me know what you guys think! Less quality but I can have a wheel cam this way with Twitch! As for the video, it's a smoother run but ended up 2 seconds slower than my personal best time.
https://www.youtube.com/watch?v=sQtOK3UqARA
Re: I still need some work but I'll get there.
Posted: Fri May 29, 2015 6:59 pm
by Trash McNish
Nice I think if you can smooth out those gear changes a wee bit you will find more time.